Midi problem (I really need Help to fix this) !!

[ni-cad]

I can't figure this out.

I have a problem with a midi signal that's running between two apps one of the apps being Res3, the other being FL Studio.

FL is sending midi to trigger an audio sample in Res3 via midiyoke, but the playback I get from Res3 is disjointed and irregular. Worst of all I can't tell which of the two apps is at fault. Below are example recordings, both apps are using the same sample of a snare, FL is playing one note after another in quick succession creating a snare roll.

One recording is the snare roll as it's played in FL (This sounds good)

One recording is the same succession of notes this time sent as midi to trigger the sample in Res3 (This sounds bad)

What's going wrong here? Obviously the midi signal is getting fowled up somewhere along the line, how can I tell which app is causing the problem, FL? Res3 or Midiyoke. Or is it something else? I highly doubt these are under runs, my cpu shows only %30 and there are only two very short wav files being triggered, both the two apps are completely empty, no automation, no vst's nothing, just this one same sample in each app.


(Straight snare Roll)

http://www.killalltraitors.co.uk/Snare_roll_test-FL.wav

(Snare Roll in Res3 triggered by midi from the same notes as above)

http://www.killalltraitors.co.uk/Snare_ ... o_Res3.wav

[ni-cad]

Well I think it has something to do with midi Jitter and my sound card, but I haven't figured out a solution yet.