in/out point sliders fft

[GeeEs]

I noticed a "visual" error in the GUI with the in/out point sliders from the fft band-range selection sliders.

When you narrow down the fft in/out point sliders to a specific range in the grafical equalizer

Clipboard01.jpg (22.58 KiB) Viewed 3155 times

then minimize the equalizer and open it again

Clipboard02.jpg (19.86 KiB) Viewed 3154 times

the "in" point is back to the left side of the equalizer... BUT... the setting is still there, so when you narrowed down a part in the high frequencies it's still responding only to that part, which is a good thing
Also... when you click the "in" point the first time it jumps back to where you set it before.

Is this just on my machines?

[syzygy]

I see this behaviour too - Windows Vista.

As you say, it doesn't affect the way the FFT behaves - it's an interface issue.

Dan