Trouble getting blackmagic intensity to work

[mcskelle]

I cant get this to work. The cards show in sources, but input are black even though a camera is attached with the hdmi inputs...
Have any of you intensity users done anything speciel to get it to work in resolume?

setup:

windows 7, 64 bit
2 blackmagic intensity pro's with 2 cameras attached
resolume 3.3.1 DEMO

[fruitygreen]

Yeah it sure does. Got Intensity Cards and Shuttle working.
You missed this.
viewtopic.php?f=7&t=7393#p27762

1st:
If your HDMI output is HDCP compatible it wont work. Black Magic is not HDCP recognized.(Probably irrelevant to cameras)

2nd:
Your Intensity capture must be set exactly to match your output device. (Example: output device=1080/30p input =1080/30p). Some devices output 1080/60p or 1080/60i and not configurable. Intensity has many available presets but often not compatible ,no 1080/60p.

[mcskelle]

Tanks a lot!

I think it a resolution match-issue then.

My camera outputs is descriped as 1920/1080i on the camera display, and as 1080i/50Hz if i hook to my tv.

[mcskelle]

By the way, It works with the blackmagic software thats come with the card.

[fruitygreen]

If you can see it in BlackMagic Express then probably you have not configured it properly in Resolume.

In Resolume, Right click the video source and make your matching resolution selection.

[gregsully]

Two questions with this..

1.Anybody using this Blackmagic to capture one PC output (DVI to HDMI)... ?

2.Whats the approx frame delay once its into resolume?

[Stickygreen]

frame delay is very little, but that depends on resolution, and computer specs. If I'm capturing full HD i can get about 1 or 2 frames delay, hardly noticeable. If I'm capturing less resolution, then it's near impossible to tell if there is any delay at all. I think this will vary depending on your CPU, and RAM of your capturing machine though..

[westframe]

Who has experience with the Intensity USB3 MacBookPro beta driver, and it's latency/delay in Resolume with a SD signal input? (HD conversion to SD-SDI output from the ATEM1, going into the Intensity composite input > USB3)

would be great to know
Thnx
R

[westframe]

All options, old new MacBooks did NOT work for me.
Might be that the Intensity box is broken?! I dont have a clue.

R