Hi Resolume community,
So I know that adding parameters to Dashboard control is easy. But what if you want to delete a certain parameter from a certain knob? Or even if you just want to see what a knob is controlling?
Thanks in advance!
Deleting Parameters from Dashboard
Re: Deleting Parameters from Dashboard
Click on the right arrow next to the parameter name and select Basic instead of Dashboard.
Joris, as a side note, I noticed that the name of the parameter gets stuck in the dashboard even when it's brought back to Basic.
As far as knowing which parameter is assigned to a knob, just look at the name below the knob and you'll know which one it is. It becomes a bit trickier if you assign more than one parameter to one knob as it'll keep the name of the first parameter assigned but you can see that name below all the parameters that are controlled by the same knob.
Joris, as a side note, I noticed that the name of the parameter gets stuck in the dashboard even when it's brought back to Basic.
As far as knowing which parameter is assigned to a knob, just look at the name below the knob and you'll know which one it is. It becomes a bit trickier if you assign more than one parameter to one knob as it'll keep the name of the first parameter assigned but you can see that name below all the parameters that are controlled by the same knob.
Re: Deleting Parameters from Dashboard
The name of a dashboard dial can be changed by doubleclicking. The first time you drag a param over it, Resolume fills out the param name for you as a suggestion. But you can change it to whatever you want.
It's not so much that the name gets stuck, it's just that it remembers the name it had before. This makes sense when using multiple params or your own custom naming conventions.
It's not so much that the name gets stuck, it's just that it remembers the name it had before. This makes sense when using multiple params or your own custom naming conventions.