AKAI APC 40- chanel changing issues

[rud-x]

hi Guys!


Sorry, if it's obvious, but is there any option to change/switch the chanel on an Akai APC 40 in Resolume 5. I mean, if i mapped 8 effects for 8 knobs for the whole composition, can I map another 8 with other effects on an other chanel?

And an other question:
If i mapped 8 buttons on a layer (for 8 clips), but i'd like to control more than 15 clips in one layer - is there any option? I think the chanel changing would be also a solution for this issue too.

Thx in advance!

[Joris]

When set to Generic mode, the APC40 will switch channels for the rotaries on the right hand side after pressing the numbered row of buttons.

viewtopic.php?f=12&t=9228

[rud-x]

Thank you very very much!