Live Input Resolution

[ameliamayscott]

Hi there,

New to Resolume. I'm bringing in some IP cams as live inputs. No capture cards as they're streaming over the network. The cameras show up fine, but they're being cropped to 640x480. Cropped, not scaled. There doesn't seem to be any option to change the resolution of my input. I've looked up how you'd do it on a capture card, but I don't have the resolution options with my input.

Is there a way to change this, or does Resolume only support certain input devices?

Thanks!

[pfelberg]

Every input source has its own properties panel after loaded into a deck. Check it out.
Anyway... cropping seems to be an issue similar I had with my capture card. Waited for seven years for a solution.

Paulo

[Zoltán]

How are you bringing in the IP cameras?
Via syphon/spout/NDI?

[ameliamayscott]

I'm using iDS Gig E cams. They go through an iDS camera manager, but I'm not having to send the feed to Resolume. No spout or anything like that. They just show up as sources in Resolume. I've tested bringing the cams into other programs like Isadora for example, and the feeds show up at full resolution no problem. I guess this is just a support issue with Resolume?

[Zoltán]

I'm using iDS Gig E cams. They go through an iDS camera manager, but I'm not having to send the feed to Resolume. No spout or anything like that. They just show up as sources in Resolume. I've tested bringing the cams into other programs like Isadora for example, and the feeds show up at full resolution no problem. I guess this is just a support issue with Resolume?

Are the cameras connected to the computer via USB?

[Joris]

And are you able to change resolution in Isadora? Or do they just default to a higher resolution?