[FIXED] Input selected at startup

[grgbrn]

Hi there !

I'm dropping a bottle to the sea :
Is there a way to have an input already selected when resolume is started ?

Let me explain :
We are building an "as possible" autonomus mapping setup, when the computer is launching, all we need is starting with a batch script.

We are launching Unity (with spout), then resolume, and etc.
But we always need to click on "SpoutOutput" (server name given by Unity by default) on Resolume to make our mapping works.

Is there a way to script that ? With options on out batch ? or ... ?

Thank you very much for your help !!!

Greg

[He2neg]

i´m sure there is... but i had a quick search in the manuell and didnt found anything...
i´ll be at my other machine with Arena tomorrow and will look there..
my guess is somewere in the preference area or the layer options.

*** till tomorrow can some1 else tell me were i find it ***


good night

[Joris]

https://resolume.com/support/en/layers# ... ip-on-load

[He2neg]

i knew it.... and i even had the words inside my head but i didnt found it yesterday

Thanks Joris.

[grgbrn]

many thanks to both of you for your very quick replies !

It looks strange because spoutOutput is my very first clip but when I launch Resolume it is in gray and I have to click on it to make it active.

Here is a screenshot of my Resolume : https://pasteboard.co/HRwzBNA.jpg

Do I have to set a specific thing ?

I'm sorry, I'm a very beginner in Resolume, don't blame me

Again, thank you very much !

Greg

[He2neg]

maybe Spout have to load or activate somehow....

Did you tryed to put a different Clip first ( maybe a Logo Still with 5 sec duraction) and autopilot to next clip?

[Zoltán]

The spout source clip should reconnect automatically after a few seconds, once the sender is active.

So if you have it launched on startup, it's grey, then after Unity starts the spout sender, the clip in Resolume should turn to a blue thumbnail automatically and show on your output.
Isn't it happening this way for you?

[grgbrn]

Folks, you're great !

we missed to right click on "layer 1" and then "first clip on load"
Wasn't very clear in documentation but, well, it's fixed

Again, thank you very much for your help and time !

Take care of yourself

Greg