Pixelmapping Astera AX-1

[FL_Light_Berlin]

Hey Guys,

Has anybody a Resolume Fixture for an Astera AX-1 Pixeltube in the RGB-S (S=Dummy) Mode Witz 16 Pixels (64 Channels)

Trank you and best Regards

[He2neg]

There is a fixture creater inside Arena, is ther something special about the "dummy" mode i´m not aware or do you have another problem?

[FL_Light_Berlin]

I know the fixture builder wich is inside Resolume. But I have more than 1000 pixels and the AX-1 are in RGB-S (S=Shutter) mode. Every Stick has 16 of these Parameters. If I build this Fixture with the RGBW-Preset, which is implemented in Resolume, I have strobing pixels if I map a black and white Clip. (Same Problem with the RGBA-Preset and red/orange Clips)
I know you can turn off the Shutter, but it will be a lot of work, because the Sticks are in trusscircles in the roof.

[He2neg]

As work arouind you can build a fixture for 1 pixel and copy this till you have one astera ready and then copy this as a whole...

inside the fixture generator you see a small + at the bottom( of the collum you can set the rgb / rgbw etc...) this add a dmx channel so you can have a rgb + Parameter Fixture.

This parameter can be set manually and hold this value.

maybe this work for you.