Clip restart on timeline mode

[boris.lema]

Hi,

I've been searching for a way to restart a clip on a specific layer and that clip is in timeline mode, NOT in BPM mode.
Its possible to restart a clip on BPM mode with the resync button near the tap but i dont think there is a possible way for timeline mode.

Any solutions must be controlled by DMX on a specific layer. and about 250 clips in that layer.

[Arvol]

map the timeline of the selected clip to a value of 0

[boris.lema]

map the timeline of the selected clip to a value of 0

Oh, didn't saw that option :p.

Will try that!

thanks!

[Zoltán]

Or just trigger the clip again?

[boris.lema]

Or just trigger the clip again?

Its oke if its only 1 clip to retrigger. But if you have 250+ clips you need to retrigger?

Retrigger the clip in a dedicated layer, and a +if its activated by pioneer bridge.

For example a nightclub with custom visuals of songs. When the dj loads a song, track get loaded in layer 8 plays, the verse is playing --> restart button (Manualy), verse is out fade out, another verse (manual restart button).

[Zoltán]

If the clip is synced to Pioneer, or Denon, you don't need to touch it, it will start with the clip + offset.
If it's synced to these, you can't restart it manually either.

If you're triggering manually, setting up a shortcut to the layer position, you might get away with only a few shortcuts.