Hi,
I have a Lenovo with Ryzen 5.
One triplehead2go
3 x Optoma eh415st projectors.
Laptop has 1 hdmi output which is connected to the triplehead2go through an adaptor display port.
Gxm is able to communicate with the projectors as the make and model is detected.
Issue is all 3 show “no signal detected “
I’m at a complete loss and would take any help I can.
Triplehead2go projectors no signal
Re: Triplehead2go projectors no signal
Are you sending a supported format to the projectors?
Software developer, Sound Engineer,
Control Your show with ”Enter” - multiple Resolume servers at once - SMPTE/MTC column launch
try for free: http://programs.palffyzoltan.hu
Control Your show with ”Enter” - multiple Resolume servers at once - SMPTE/MTC column launch
try for free: http://programs.palffyzoltan.hu
Re: Triplehead2go projectors no signal
maybe a hdcp issue... you can try to switch this off inside the gfx settings...
Laptop: XMG P507 // Intel i7-5500 / GTX-1060 / 1tb SSD / 32gb RAM // Lemur / BirdDog Studio NDI
~self employed AV technician / Schu.VT|a|posteo.de~
~Berlin~
~self employed AV technician / Schu.VT|a|posteo.de~
~Berlin~
Re: Triplehead2go projectors no signal
Hi Gmag20,
you wrote that you are using an Hdmi to Displayport adapter/adapter cable.
This signal direction (HDMI>DP) will only work if you are using an "active" Adapter.
May you share the adapter model you are trying to use?
Best wishes
cosmowe
you wrote that you are using an Hdmi to Displayport adapter/adapter cable.
This signal direction (HDMI>DP) will only work if you are using an "active" Adapter.
May you share the adapter model you are trying to use?
Best wishes
cosmowe
Do you like outlines? Easy Outliner on Juicebar