Pb to capture live video with Blackmagic Recorder 3G. Blocked to NTSC

[jobee]

Hey folks,
I try to make a good capture of a live video with a Canon Mark3 with a Blackmagic Ultrastudio Recorder 3G to Resolume Avenue.
If I connect the Canon Mark3 to a video-projector I can check that the video stream is 1080. I choosed a PAL Output via HDMI in the Canon MARK3 option.
But when I add this stream as a source in Avenue the flux comes to 720x486 in NTSC. I can't change it.
I spent 6 hours watching all documentation about Canon, Blackmagic, Resolume, I can't figure how to solve it !!!
Could you have any idea?
Best regards

[Zoltán]

What does Blackmagic desktop video say about the format?

[jobee]

It says this is a 525i59.94 NTSC, REC.601 signal
But when I plug the Canon to a video-projector, the projector project a 1080 video !!!

[Zoltán]

Is this the Canon 5d mark3?

How about BMD media express, what resolution does it capture?

[jobee]

Yes,
It says in BMD media express that it capture 525i59.94 NTSC, REC.601 signal. And yes this is the Canon 5d mark3.
Whichever settings I tried in Canon, I can't get a good signal. I tried HDMI cadency 24p or 60i or Auto. I can't choose the HDMI output resolution in the Canon menu.

[Zoltán]

Ok, sounds like the camera is sending that format then.
I'd recommend contacting Canon about this, maybe you need a firmware update to enable full HDMI resolution support.

[jobee]

Yes, you're right Zoltan.
I have to contact Canon.
Thx !