If you experience a leak with outputs via a DeckLink card and have your color range set for the DeckLink output to Full RGB, then you can downgrade one micro step from 7.21.3 to 7.21.2, this should fix the leak.
The leak you are experiencing is another leak than the one that the initial thread was about. For the memory leak with USB capture cards you'd need to roll back to 7.18.2. Both memory leaks should be fixed with 7.22.0.
Memory leak on capture device
-
Full Spectrum
- Posts: 91
- Joined: Wed Oct 19, 2016 01:55
- Location: Los Angeles, CA
Re: Memory leak on capture device
judicator seemed to indicate that it's on 7.19.2, 7.20.1, and 7.21.3
And it's hard for me to say where the leak is coming from. Here's everything the system is doing:
2x PTZ camera input via NDI|HX
2x PTZ camera input via 3G-SDI into a Decklink Quad 2
6x Projector Outputs via 3G-SDI from the Decklink Quad 2
Either way, I appreciate the update. Again, it's too late for me to do anything about it for my current show, as we're in the run and the team feels it would be too dangerous to update or change anything if we've got enough stability to get through each night. It's a good thing our system had 128GB of RAM, because by the end of the run each night we've got about 60 GB of memory that persists and Resolume needs to be force quit.
And it's hard for me to say where the leak is coming from. Here's everything the system is doing:
2x PTZ camera input via NDI|HX
2x PTZ camera input via 3G-SDI into a Decklink Quad 2
6x Projector Outputs via 3G-SDI from the Decklink Quad 2
Either way, I appreciate the update. Again, it's too late for me to do anything about it for my current show, as we're in the run and the team feels it would be too dangerous to update or change anything if we've got enough stability to get through each night. It's a good thing our system had 128GB of RAM, because by the end of the run each night we've got about 60 GB of memory that persists and Resolume needs to be force quit.
Re: Memory leak on capture device
Yeah as mentioned there are 2 different issues discussed in this thread now.
I assume your memory leak is the one happening with outputs via Blackmagic cards that sneaked in with 7.21.3, so the solution for this is to roll back to 7.21.2.
The issue that judicator is talking about was related to some USB capture devices on Windows 11 and this happened since 7.19.
As said, both issues should be fixed with 7.22 once we can release that.
I assume your memory leak is the one happening with outputs via Blackmagic cards that sneaked in with 7.21.3, so the solution for this is to roll back to 7.21.2.
The issue that judicator is talking about was related to some USB capture devices on Windows 11 and this happened since 7.19.
As said, both issues should be fixed with 7.22 once we can release that.
Re: Memory leak on capture device
I can add, what i used also Blackmagic UltraStudio Mini Recorder and with device i dont have memory leak now on current version (7.21.3 rev 38686).