how to drive resolume with ableton midi out..??

Anonymous · Post by **Anonymous** » Wed Nov 23, 2005 19:48

hello all

im new in ableton live and with a friend i'm trying to trigger clip in resolume controlled by midi out from ableton live...
but i don't knot exactly how u need to connect my periferics..
i have the two behringer midi controller (the bcf and bcr)

At the moment i'm using the bcr with ableton and have the3 midi out from ableton in the bcr and through bcf in resolume ...

It's this the right midi connection setup that u advice me to use?

i can see the midi in , in the midi controller connected to resolume but i don't know how to assign this incoming midi to resolume, how to use it to drive the function i need .

thanks
eon

Anonymous · Post by **Anonymous** » Tue Dec 20, 2005 16:57

You can control resolume straight from Ableton, connecting both computers with a midi interface.
Just create a new midi track in Ableton and set the midi out config to send the signal to your midi interface. Then, just play any note on ableton and assign it to any effect you want in resolume.

[]s
1mpar

massimiliano · Post by **massimiliano** » Mon Dec 26, 2005 20:20

Hi!!
I have 2 midi controller like you, some BCR and some BCF. I use ableton with them.
But i have one problem: after to have connected the 2 behringer in modality USB4, when I open ableton the software sees only the controller direct connect to my pc. Can you tell me as you have connected the PC and the two behringer?

thanks a lot, because I do not know just that to make.

Massimiliano