Pixel mapping issues

[Mish]

Hi,

I followed the manual page to set up pixel control and I am running into difficulties.

1) currently I cannot output anything to the pixel tape. I set up my lumiverse, a 150 lengthy pixel tape, I assigned it to the composition window and see the levels output in dmx output.

2) then I went to preferences to assign the lumiverse to an artnet address. My pixel controller starts on universe 41 which I believe is Artnet 2:8 or something similar. I press refresh devices and it should be good to go.

But nothing happens. No response. From the same computer in Eos lighting software I can speak to the artnet interface so I do not believe it's a connection problem

One thing of note is that under preferences - dmx output I get no option for artnet to broadcast, unicast, etc. The option isn't there at all. I think the ultimate problem is that resolume isn't actually outputting artnet.

Any help is appreciated. Thanks

[Joris]

First thing you'll want to do is update to the latest version

[SystemD]

I have the same project, and it works.
See this topic : viewtopic.php?f=6&t=13885
And my blog : http://divisionpixel.com/configurer-ser ... e-arena-5/

[drazkers]

Are you sure you clicked output and not input?

If your on the latest version and don't see broadcast or unicast options you clicked input.

I did the same thing this week!