How on Earth do you use Resolume with one screen?

gpvillamil · Post by **gpvillamil** » Tue Apr 19, 2005 05:36

OK, I started Resolume & loaded a deck. Then I went to screen setup and set the primary to fullscreen. (I have two monitors, but for a specific application I want to run only one screen).

Got a white screen. Used Alt-Tab to find the Resolume output window, which ran fine. I could cue up video clips, no problem.

Now, how can I switch back to seeing the user interface?

I was able to Alt-F4 to quit, though that gave me a funky error message on the way out.

What I want to do is this - I have a webcam on top of a large TV, I want to run that into Resolume, apply effects, and play it back full screen. The computer connected to the TV only has a single video output, so I want to set up the decks and effects and then switch to fullscreen.

Post by **edwin** » Tue Apr 19, 2005 09:19

Press CTRL+ENTER to return to the screen setup.

edwin

gpvillamil · Post by **gpvillamil** » Tue Apr 19, 2005 14:09

Will this retain the current state, ie. currently playing layers and effects?

Also, is there any way of specifying which effect slot an effect will be added into, from the keyboard?

Basically, if state is not saved, I need to be able to load up 2 or 3 effects in different slots.

sblurg · Post by **sblurg** » Tue Apr 19, 2005 22:52

same problem here.
When I contr+enter the menu is not visible, I can see it appear a flash second when I hit enter, and then it's gone

gpvillamil · Post by **gpvillamil** » Tue Apr 19, 2005 23:02

This is not really working for me. The preview mode (user interface) works fine. However, setting the main monitor to fullscreen just leads to a white screen. Ctrl-enter works OK, however after going to fullscreen clips won't play. Decks will load fine, but selecting a clip just leads to a white screen in the preview window.

Resolume 2.2
Win XP SP2
Shuttle ST61G4, Pentium 4 @ 3.2Ghz
ATI Radeon 9600 SE