Connecting to Chauvet Epic 900 drive
-
Kristismith
- Posts: 1
- Joined: Thu Mar 12, 2020 14:00
Connecting to Chauvet Epic 900 drive
Hey has anyone used Resolume to control Chauvet's Epix strips or bars? I have a demo of the 900 drive and a epix tour bar. The drive doesn't show up in the advanced settings and I've tried the target IP address but nothing.
Re: Connecting to Chauvet Epic 900 drive
Did you select the DMX network interface in the Resolume preferences? https://resolume.com/support/en/dmx#pic ... -interface
Software developer, Sound Engineer,
Control Your show with ”Enter” - multiple Resolume servers at once - SMPTE/MTC column launch
try for free: http://programs.palffyzoltan.hu
Control Your show with ”Enter” - multiple Resolume servers at once - SMPTE/MTC column launch
try for free: http://programs.palffyzoltan.hu
-
boris.lema
- Posts: 72
- Joined: Sat Oct 07, 2017 14:10
- Location: Belgium
Re: Connecting to Chauvet Epic 900 drive
i do from time to time, it works great! The company that i work for during summer uses resolume only for epix strips because its easier to map and configure the strips.
Are your drivers set to Art-Net? You use the Ethernet out of your pc or first go to a switch, than to the drivers. Your PC ip should be in the same IP range of you driver. I know there is a startup/connection time. Sometimes they pop up in seconds and sometimes you need to wait a minute untill they pop up....
Are your drivers set to Art-Net? You use the Ethernet out of your pc or first go to a switch, than to the drivers. Your PC ip should be in the same IP range of you driver. I know there is a startup/connection time. Sometimes they pop up in seconds and sometimes you need to wait a minute untill they pop up....