GeForce4 4200

FranÃ§ois_ · Post by **FranÃ§ois_** » Tue Nov 04, 2003 15:37

Hi,

I just bought a new dell computer with a 15.4 sceen (kind of widescreen view with a resolution of 1680x1054) with a geforce4 4200 onboard.

When I resize the dual screen to 1024x768 and 800x600 for the s-video out... it's look good, when the I don't resize to a fullscreen view. When I try to put it a full screen... the output look posterize and pixelate.

Any clue? Does Resolume support geforce4 4200?

FranÃ§ois_ · Post by **FranÃ§ois_** » Tue Nov 04, 2003 15:46

Actually it's a 64MB DDR NVIDIA GeForce 4 4200 Go AGP 4X Graphics...

Post by **bart** » Tue Nov 04, 2003 18:49

how do you set the output to fullscreen on the second screen? try maximizing it ... please see out manual to find out how to do this ...

FranÃ§ois_ · Post by **FranÃ§ois_** » Tue Nov 04, 2003 19:25

I do the ctrl+alt+2 (at this point what I see is perfectly clear on the tv out... and after that, I do ctrl+alt+enter... at this point it goes solarize+pixale... if I stress the coner of the output... it goes well till I get near the fullscreen...

FranÃ§ois_ · Post by **FranÃ§ois_** » Tue Nov 04, 2003 21:02

shit... if I strech the corner of the output... sorry for that bad writing...

FranÃ§ois_ · Post by **FranÃ§ois_** » Wed Nov 05, 2003 15:13

Hi...

I try many way to configure that video card... and the problem comes from the widescreen.

So I figure it out by trial and error until I found the best solution. It consist of configurating the output at 640x480 and by a right click on the right of the caption bar and the output window I managed to find the best resolution... If I do the ctrl+alt+enter... it strech to fit on the widescreen 15.4". I will give a try to the ctrl+alt+m this afternoon.

thanks... for your time...

Best regards,