Resolume Forum

Hi all,
I having problem with capture card (Blackmagic Studio Decklink 4K), I running with 4x 4K output, when only play clip the fps still 60 but the problem when I play the capture card 4K@30Hz input, the fps drop down a lot, only around 30fps.
After that I changed to datapath capture card, the ...

Hi Christoph,
I change the output audio out of "select" mode then it works now. Thank you so much.

Hi all,
I having problem with new launching 7.21.3. It cannot load the example composition or any, I tried downgrade the older version but it only can work with 7.13.2. I even tried to re-install windows, swap SSD, install on difference hard disk but still same.
My system is: 2 CPU Xeon Silver 4114 ...

Dear Arvol,
You correct because I tried test all GPU same CPU0 and setting all in Nvidia control for A5000, the fps better and stable around 50-60fps but the other problem coming is it always use 3D-copy of A5000 and used 90-100%, I have to re-start resolume 2 or 3 times it will become normal.
All ...

Dear Resolume team and group,
I have built the resolume server as spec below:
* Processor: Dual XEON CPU 3.0G 18M 12C 4189P Gold 5317
* Memory: 64G (16G per DIMM) DDR4 REG
* Storage: 2 x SSD 2.5" 512GB 3D TLC BICS5 (0~70C); (Support 8 x 2.5/3.5" trays SSD/HDD (Hot-swap); 1 x M.2 2280 B+M key (SATA ...

Zoltán wrote: Tue Dec 13, 2022 10:39 Check composition master https://resolume.com/support/en/composition#properties

All opacity master is 100%, so that why I feel strange. I used resolume for a lot of project never measure until we got some new projector and tested it.

Dear,
A few days ago, we tested our new projector and feel the brightness not good when output from resolume.
We measurement if output direct the brightness ok but when use resolume software it reduce 25%, anyone met this symptom before?
Hope anyone can help, the brightness very important.
Many ...

Hi,
How about the resolution? i think with 12 projectors it very big, if all fullHD, I estimate around 18K x 1080 or smaller so with GUI is onboard impossible because resolume use GUI (monitor) for rendering.
I suggestion if you want use Quadro so testing with RTX4000 or 5000 for GUI, extend output ...

Dear,
I have 2 server with Master and Slave control via OSC, all comp in 2 servers same but when I play clip in Master, it will trigger slave play also but the audio have some noise or not clear in Slave server (audio in master still OK), I did not know why like that hope some master guys saw it ...

Dear,
I have event mapping on the sphere, I searched in forum and have a bit information about this but still want make sure have some pro guy did it with resolume before.
I will use 3 projector portrait to mapping 220 degrees on the sphere diameter 7m.
I also bought the small balloon to testing, I ...