Resolume Avenue 7.2.1
Windows 10
I have a problem which I believe is a duplicate of this issue from a few years ago: viewtopic.php?f=12&t=16485
I have a set of clips that are bpm synced with a pattern of "2 beats, 2 beats, 4 beats". The first and third clip of each set are Beat Snapped to 1 bar and the second clip is Beat Snapped to 1/2 bar. All clips are set to loop exactly once in Autopilot.
90% of the time, the clips will Autopilot correctly: 2-2-4-2-2-4; but about 10% of the time, which is a lot in this case considering how often the clips are triggered, a clip will repeat and mess up the structure of the sequence. The Beat Snap settings will correct this a little bit by repeating other clips until the pattern is back in phase, but the problem is still very noticeable.
Here's a video of my issue: https://vimeo.com/470341575. I trigger the sequence at 5 seconds, and you see the third clip immediately repeat at 8 seconds. The repeats have no pattern. If a particular clip repeats on one pass of the sequence it may or may not do the same during another pass.
I've seen the solution of "make a single clip" so that I don't have to use Autopilot, but A) that's a lot of work to find all the speeds that the clips are stretched to for the beat sync to work, especially since I do a lot of fine adjustments to the start and stop of each clip and B) I would like to be able to do live changes to my clip decks quickly. I feel like this solution is like saying "don't use Autopilot because it's broken"
Hopefully this issue isn't embedded deep in how you guys implemented your render pipeline. Autopilot is potentially such a cool feature and I'd love to be able to use it to its full potential.