Advanced output and test card

[ulisses]

Hello,

Should test card output to all displays at same time in advanced output?
Im asking because sometimes I can output the test card in all outputs and sometimes not.
Output in resolume window shows the test card, but projectors outputs are white or black ( ati hd 7800 eyeinfinity 6)
If i reset the displays setup, inside advanced window, it shows all test cards.

Thanks,
Ulisses

[Oaktown]

Yes, the test card sized to the resolution of your composition outputs to all slices.

Keep in mind you will see only the section that is selected in the [Input Selection] and it will be affected by the settings in [Output Transformation] and the [Soft Edge] parameters.

[Zoltán]

and layer routed slices don't display the rest card.

I read your post again...
could be a driver issue, if the same output setup sometimes shows white slice,
also look at the memory footprint of resolume (ram) it shouldn't be near 1.8-2GB.

[ulisses]

I was testing with 5 projectors and default setup, one slice per projector covering the whole area.
Test card always show per projector (ctrl shift 2, 3, etc) but when I enter advanced it shows white in all projectors and slice adjust window is dimmed.
If I reset slices to default again, test card shows in all projectors at same time.
I'll test drivers, just found that when using 2 projectors it works.

Tks!